Pima Hunter-Pro 32 - Keys Function

HUNTER-PRO 32 Intruder Alarm System - Installation Manual
10
NOTE:
If technician selected PIMA display, the system will not display the
zone status during faults. Only after faults resolved, PIMA Display
renews.
2.2 Keys’ Function
Operating and programming the system commences by first entering the
Master Code and then pressing any further required keys. However, a
number of keys enable certain actions by a single long press, without the
Master Code:
Function
Key
After entering Master Code
(short press)
Secondary Function
(long press)
System Arming/Disarming Fast arming the system (if
enabled by technician)
Display arming, alarm, and fault
histories
-
Temporary bypass of zones
-
Arming the system to mode “Home
1” (partial arming)
Fast arming the system to
“Home 1” mode (if enabled by
technician)
Display menu (see section “Zone
Status Display”)
-
Programming telephone numbers
-
Arming the system to mode “Home 2”
(partial arming)
Fast arming the system to
“Home 2” mode (if enabled by
technician)
Programming time and date
-
Programming the user codes
-
Programming zones for Chime feature Enabling/Disabling the Chime
feature
Programming automatic arming
-
Programming key Smoke detector reset