HUNTER-PRO 32 Intruder Alarm System - Installation Manual
6
To reduce the risk of fire or electric shock, do not expose this
alarm system to rain or moisture.
Do not open the door of the alarm system. Dangerous high
voltages are present inside of the enclosure. Refer servicing to
qualified personnel only.
This alarm system should be used with AC 230V, 50Hz. To
prevent electric shocks and fire hazards, do NOT use any other
power source.
Do not spill liquid of any kind onto the unit. If liquid is
accidentally spilled onto the unit, immediately consult a qualified
service.
Install this product in a protected location where no one can trip
over any line or power cored. Protect cords from damage or
abrasion.
Disconnect all sources of power supply before proceeding with
the installation.
Connect the AC wires to the terminal block on the PCB as
marking. Pay attention to polarity.
1.3 Signs and Abbreviations Key
Regular key press
Long key press, until confirmation beep is heard
Press this key at any programming stage in order to
return to root screen
Default Master Code: 5555
Enabled User Code: A code enabled, by Master Code, to enter
User Menus
LCD Zone Numbers: Referring to the frame of zones engraved
above and below the LCD display window,
indicating the zones’ numbers.
To Next Page
Loading...
