HUNTER-PRO 32 Intruder Alarm System - Installation Manual
40
CHAPTER 5:
TROUBLESHOOTIN
G
NOTE:
If more then one failure is detected, the display will scroll the
failure list one after the other. If more than one keypad is
connected to the HUNTER-PRO, and you are programming
the system from one keypad, then the display on all other
keypad will display:
Other Keypad in Use
This
will also be displayed whenever the installer uses a modem in order
to program the HUNTER-PRO, or when someone is in control of the
HUNTER-PRO
via telephone.
The following table describes the possible Alarm System Faults:
Displayed
Fault
What can I do?
Battery Wait approximately 24 hours for the indication to
disappear. If the fault indication persists longer then one
day, the back-up battery should be replaced.
Wireless
Receiver
A wireless receiver failure can be the cause of
communication failure between the detector and
receiver.
AC voltage Usually appears during a power failure. If other electrical
appliances in the house are operating, check the switch
or fuse to which the alarm system is connected. If the
cause of the fault is unclear, call the installer.
To Next Page
Loading...
