Pima Hunter-Pro 32 - Page 41

HUNTER-PRO 32 Intruder Alarm System - Installation Manual
41
Clock Appears following a prolonged power failure during which
the backup battery was completely discharged. Set time
and date (see section 3.8.4)
Phone Perform “system self-test” (see section 3.6). Verify during
the test that other instruments connected to the Alarm
System’s telephone line (i.e., telephone sets, facsimiles,
etc.) are not active. If the fault persists, call the installer.
Tamper 1 Tamper switch 1 is open. Call the installer.
Tamper 2 Tamper switch 2 is open. Call the installer.
Low pwr Appears before the back-up battery is completely
discharged, usually after a prolonged power failure.
Follow instruction for low battery failure.
EEPROM Parameter programming fault. Call the installer.
Zone Trb. One of the protected zones is faulty. Call the installer.
ROM Software failure. Call the installer.
RAM System failure. Call the installer.
Commun. Failure to communicate with Monitoring Station. Call the
installer.
Det. Vltg Detector power supply. Call the installer.
Keypad not
connected
No communication between the keypad and the
HUNTER-PRO motherboard. Call the installer.
Other
display use
Programming is done from another keypad or system is
controlled via telephone.
APPENDIX: user notes
P/N 4410128 Rev. A (June-2004)