HUNTER-PRO 32 Intruder Alarm System - Installation Manual
21
Phone key: Function:
1 Arm the system
2 Disarm the system
4 Arm the system in “Home 1” mode
5 Switch on the Relay
6 Switch off the Relay
7 Arm the system in “Home 2” mode
8 Listen in (only available with a MIC-100)
0 Disables siren and dialer (in case of an alarm).
NOTE:
The alarm system confirms the command was received by two
short beeps.
While the system and the telephone are communicating, the
following message will display on all connected keypads:
“Other keypad in use”.
If the system does not receive any command for a period of 60
seconds, it shall disconnect and return regular operation mode. The
system will remain in standby (with the above displayed on keypads)
for another 60 seconds before keypad operation returns.
To Next Page
Loading...
