HUNTER-PRO 32 Intruder Alarm System - Installation Manual
32
minute of not receiving any command (see “
Remote Control via
Touch-tone Phone
” on page 20).
NOTE:
In case a Voice-Unit is connected to the system, once the
call is picked-up, there is a recorded message, and not a
warning sound.
The dialer aborts the dialing attempts in the following cases:
The system’s status changes from ON to OFF
A “Stop Siren/Dialer” command was received via telephone. The
first Private Dialer User that gives an ‘abort’ command causes
the other Private Dialer Users in the phone list will not receive
the system’s report.
All Private Dialer Telephone Numbers were dialed to twice
4.3.1 Programming Telephones
It is possible to combine the process of Entering/Deleting/Changing
programmed telephone numbers once in the Telephone Menu.
4.3.1.1 Programming User’s Authorizations
Master Code/Enabled User Code/Zero long press+User Code
Enter 1 telephone number
Enter 2 telephone number Enter 2 telephone
number Enter 3 telephone number
Enter 3 telephone number
4.1.1.1 Deleting a Programmed Telephone Number
To delete a programmed telephone number, press the
key
instead of the telephone number.
To Next Page
