136
Menu Mode
6) PURECINEMA Setting
The PURECINEMA function automatically detects video signals such as movies that are filmed at 24 frames per
second then converts them to a progressive video signal by a 2-3 pull-down process. Normally, when the PURECINEMA
function is used, the ‘ON’ setting should be used.
The PURECINEMA setting should be performed for each input (INPUT1 to INPUT5) and each signal.
Settable condition: When there is INPUT1, INPUT3 to INPUT5 video signal input
Factory setting: OFF
1 Select ‘SETUP’.
2 Place the cursor over ‘PURECINEMA’ then press the [SET]
button.
3 Each time a [2/3] button is pressed, the setting changes
as shown below.
• OFF .................. I/P conversion is performed without
detecting the signal of the film source
• ON .................... The film source signal is detected then
the I/P is converted
Note
The modes that can be selected differ. Specific information is available on the next page.
3 OFF 2
3 ON 2
:
PURECINEMA OFF
SET
SET
EXIT
MENU
Screen 3
MENU INPUT1
ENTER
SET
EXIT
MENU
SCREEN SETUP OPTIONPICTURE
:DISABLE
:MIDDLE
COLOR TEMP. :MIDDLE
AUTO POWER OFF
DNR
:LOW
:ON
MPEG NR
CTI
:OFF
:RGB
PURECINEMA
COLOR DECODING
:AUTOCOLOR SYSTEM
SIGNAL FORMAT
Screen 2
To Next Page
Loading...
Need help?
General