127
Menu Mode[Applicable only when a PDA-5003/PDA-5004 is installed]
9) Signal Format Setting
This display automatically identifies PC signals and video signals such as from a DVD player by the frequency of the
input signal. The panel is equipped with a function for identifying the resolution of a PC signal.
Factory setting: AUTO
1 Select ‘SETUP’.
2 Place the cursor over ‘SIGNAL FORMAT’ then press the
[SET] button.
3 Press the [2/3] buttons to change the setting.
Each time a [2/3] button is pressed, the signal format
changes as shown below.
• AUTO ........ It is distinguished as in “5.1.3 List of
Input Correspondence Signals 1) Input
correspondence signals personal
computer signals” (pg. 80 to 82)
• Others ....... Selectable resolutions are displayed
Note
The display method and selectable screen size differs for each setting. In order to obtain a proper reproduction
method and screen size, check the signal format setting when the signal is input. Change the setting as necessary.
MENU INPUT1
ENTER
SET
EXIT
MENU
SCREEN SETUP OPTION
:DISABLE
:MIDDLE
COLOR TEMP. :MIDDLE
AUTO POWER OFF
DNR
:LOW
:ON
MPEG NR
CTI
:OFF
:RGB
PURECINEMA
COLOR DECODING
:AUTOCOLOR SYSTEM
SIGNAL FORMAT
PICTURE
Screen 2
:
SIGNAL FORMAT
AUTO
SET
SET
EXIT
MENU
Screen 3
3 AUTO
Others 2
2
3
To Next Page
Loading...
Need help?
General