Piper PA-28RT-201T - Page 32

PERIODIC INSPECTIONS. (cont)
—NOTE—
Perform all inspections or operations at each of the inspection
intervals as indicated by a circle (O). (See Notes 1, 2 and 3.)
F. FUSELAGE AND EMPENNAGE GROUP (cont)
6. Inspect antenna mounts and electric wiring for security and
corrosion in plugs..................................................................................... O O O
7. Check hydraulic pump fluid level (Fill as required)................................ O O O O
8. Inspect hydraulic pump lines for damage and leaks ................................ O O O
9. Inspect for obstructions and contamination in inlet of backup
landing gear extender actuator inlet head................................................. O O O O
10. Inspect air conditioning system for freon leaks ....................................... O O O
11. Check freon level in sight gauge of receiver-dehydrator......................... O O O O
12. Inspect air conditioner condenser air scoop rigging ................................ O O O O
13. Inspect fuel lines, valves, sender units, and gauges for damage and
operation................................................................................................... O O O
14. Inspect security of all lines....................................................................... O O O
15. Inspect vertical fin and rudder surfaces for damage ................................ O O O
16. Inspect rudder hinges, horn and attachments for damage and operation. O O O
17. Inspect vertical fin attachments................................................................ O O O
18. Inspect rudder hinge bolts for excess wear (Replace as required)........... O O O
19. Inspect rudder control stops to ensure stops have not loosened
and locknuts are tight............................................................................... O O O
20. Inspect stabilator surfaces for damage..................................................... O O O
21. Inspect stabilator, tab hinges, horn and attachments for damage
and operation............................................................................................ O O O
22. Inspect stabilator attachments.................................................................. O O O
23. Inspect stabilator and tab hinge bolts and bearings for excess wear
(Replace as required)................................................................................ O O O
24. Inspect stabilator control stops to ensure stops have not loosened
and locknuts are tight ............................................................................... O O O
24a.Inspect stabilator trim mechanism ........................................................... O O O
25. Inspect fuselage wing attach fittings for corrosion, general condition and
security. (See latest revision of Piper Service Bulletin 977.)................... O O O
26. Inspect all cable tensions (use tensiometer) (See Note 19)...................... O O O
27. Inspect cables, aileron, rudder, stabilator, stabilator trim, turnbuckles,
guides and pulleys for safety, damage and operation (See Note 27)........ O O O
28. Inspect and lubricate stabilator trim drum screw..................................... O O
29. Inspect stabilator balance weight attachments and arm for security
and condition............................................................................................ O O O
30. Inspect emergency locator transmitter battery for replacement
date per Maintenance Manual (Refer to latest revision of Piper
Service Letter No. 820)............................................................................ O O O
31. Clean and lubricate all exterior needle bearings...................................... O
5-20-01
Page 5-09
Interim Revision: February 27, 1995
1B8
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
Nature of Inspection
Inspection Time (hrs)
50 100 500 1000