Piper PA-28RT-201T Service Manual

Figure 71-1. Engine Installation (PA-28RT-201T) (cont.)
INSTALLATION OF ENGINE. (Refer to Figure 71-1.)
Prior to installing the engine, be sure to install all items that were removed after the engine was removed
from the aircraft.
—NOTE—
Remove all protective caps and identification tags as each item is
installed.
1. Install the shock mount in the engine mount and hoist the engine into position on the mount.
2. Install the lower shock mount assemblies and mounting bolts. Torque the bolts 450 to 500 inch-
pounds.
3. Route and connect the throttle and mixture control cables and adjust.
4. Route and connect the propeller governor control cable and adjust.
5. Connect the alternate air cable and adjust.
6. Reconnect all lines and hoses previously disconnected from the engine.
—NOTE—
Apply Lubon No. 404 to all male fuel systems fittings. Do not
allow to enter system.
Effectivity 71-00-04
PA-28RT-201T Page 71-09
Revised: August 17, 1982
3B22
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL

Piper PA-28RT-201T Specifications

General

Brand	Piper
Model	PA-28RT-201T
Category	Aircrafts
Language	English