ELECTRICAL SWITCHES AND CIRCUIT BREAKERS.
The switches are of the rocker type. The switches are mounted in the middle of the instrument panel. The
circuit breakers are single hole mounting, pushbutton type with manual reset; they must reset be the pilot
whenever tripped. They are on a circuit breaker panel on the lower right hand corner of the instrument panel.
REMOVAL OF ELECTRICAL SWITCHES.
1. For a particular switch removal, remove the screw above the screw below the switch on the front of
the instrument panel.
2. From behind the instrument panel remove the switch, and disconnect the electrical connections.
—NOTE—
Make note of the placement of the electrical leads to facilitate
reinstallation.
—END—
39-40-02
Page 39-01
Revised: July 13, 1983
2I4
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
To Next Page
Loading...
Need help?
General