CARGO.
REMOVAL OF BAGGAGE DOOR.
With the door open remove the hinge pin from the hinge and remove the door.
INSTALLATION OF BAGGAGE DOOR.
Place the door in position so that the hinge halves are properly matched and install the hinge pin. It will not
be necessary to replace the hinge pin with a new pin if it is free of bends and wear.
REMOVAL OF BAGGAGE DOOR LOCK ASSEMBLY.
1. With the door open remove the nut from the back of the lock assembly by use of a special made
wrench. (This tool may be fabricated from the dimensions given in Chapter 91.)
2. Remove the lock assembly through the front of the door.
INSTALLATION OF BAGGAGE DOOR LOCK ASSEMBLY.
1. Place the lock into position for installation.
2. Install the nut on the lock assembly and tighten with the use of a special wrench.
REMOVAL OF BAGGAGE DOOR HINGE.
1. Remove the door from the airplane as described in Removal of Baggage Door.
2. Remove the hinge half from the airplane or door by drilling out the rivets and removing the hinge.
INSTALLATION OF BAGGAGE DOOR HINGE.
1. Place the hinge halves together and install the hinge pin.
2. Install the door into the closed position and drill the two end rivet holes and install the rivets.
3. Operate the door and check for proper fit and installation. Drill the remaining holes and install the
rivets.
—END—
52-30-06
Page 52-06
December 1, 1978
2J8
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
To Next Page
Loading...
Need help?
General