PERIODIC INSPECTIONS. (cont)
—NOTE—
Perform an inspections or operations at each of the inspection
intervals as indicated by a circle (O). (See Notes 1, 2 and 3.)
H. LANDING GEAR GROUP
1. Inspect oleo struts for proper extension (Check fluid level as
required).............................................................................................. O O O O
2. Inspect nose gear steering control and travel...................................... O O O
3. Check wheels for alignment................................................................ O O O
4. Put airplane on jacks........................................................................... O O O
5. Inspect tires for cuts, uneven or excessive wear and slippage............ O O O
6. Remove wheels, clean, check and repack bearings ............................ O O O
7. Inspect wheels for cracks, corrosion and broken bolts ....................... O O O
8. Check tire pressure.............................................................................. O O O O
9. Inspect brake lining and disc............................................................... O O O
10. Inspect brake backing plates............................................................... O O O
11. Inspect brake and hydraulic lines........................................................ O O O
12. Inspect shimmy dampener .................................................................. O O O
13. Inspect gear forks for damage............................................................. O O O
14. Inspect oleo struts for fluid leaks and scoring..................................... O O O
15. Inspect gear struts, attachments, torque links, retraction links and
bolts for condition and security........................................................... O O O
16. Inspect downlock for operation and adjustment (See Note 20).......... O O O O
17. Inspect torque link bolts and bushings (Rebush as required).............. O O
18. Inspect drag and side brace link bolts (Replace as required).............. O
19. Inspect gear doors and attachments .................................................... O O O
20. Inspect warning horn and light for operation...................................... O O O
21. Retract gear- check operation ............................................................. O O O
22. Retract gear- check doors for clearance and operation....................... O O O
23. Inspect anti-retraction system ............................................................. O O O
24. Inspect actuating cylinders for leaks and security .............................. O O O
25. Inspect all hydraulic lines, electrical leads, and attaching parts
for security, routing, chafing, deterioration, wear and correct
installation (See latest revisions of Piper Service Letters
808 and 810) ....................................................................................... O O O
26. Inspect position indicator switch and electrical leads for
security................................................................................................ O O O
27. Lubricate per lubrication chart............................................................ O O O O
28. Insure landing gear is down and locked; then remove airplane
from jacks............................................................................................ O O O
5-20-01
Page 5-11
Revised: December 21, 1981
1B10
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
Nature of Inspection
Inspection Time (hrs)
50 100 500 1000