LANCE II SERVICE MANUAL
TABLE III-I. INSPECTION REPORT
- NOTE-
Perform all inspections
or operations at each interval
as indicated
by a circle (0).
Nature of Inspection
A.PROPELLER GROUP
1. Inspect spinner
and back plate ......................................
2. Inspect
blades for nicks and cracks
..................................
3. Inspect
for grease and oil leaks ......................................
4. Lubricate propeller
per lubrication chart (section
II) ...................
5. Check spinner mounting brackets ....................................
6. Check propeller mounting bolts and safety (check torque if
safety is broken) ...................................................
7. Inspect hub parts for
cracks and corrosion ............................
8. Rotate blades and check for tightness in hub
pilot tube .........................................................
9. Remove propeller; remove sludge from propeller and
crankshaft ........................................................
10. Inspect complete propeller and spinner assembly for
security, chafing, cracks, deterioration, wear, and correct
installation .......................................................
I 11. Overhaul propeller
(see note 22) .....................................
Inspection Time (hrs)
50
100
500 1000
0
0
0
0
O O O
O O O
O O O
O O O
O O O
0 0 0
0 0 0
O O O
O O O
O
O
O
0 0
0
B. ENGINE
GROUP
WARNING
Ground
magneto primary
circuit before
working on
engine.
NOTE: Read
notes 5, 24
and 25 prior to completing
this inspection
group.
I.
Remove engine
cowl and inspect
for damage ..........................
2. Clean and check cowling for cracks, distortion, and loose or
missing fasteners ..................................................
3. Drain
oil sump (see note 6) .........................................
4. Clean suction oil
strainer at oil change (check
strainer for
foreign particles) ..................................................
0
0
0
O
O
O 0 0
0 0 0
0 0 0
0 0 0
INSPECTIONINSPECTION
Interim
Revision:
9/20/86
1D12