Piper PA-32RT-300T User Manual

LANCE
II SERVICE
MANUAL
TABLE
III-I.
INSPECTION
REPORT
Inspection Time (hrs)
Nature of Inspection
50
100
500 1000
B. ENGINE GROUP (cont.)
5. Change
full flow (cartridge
type) oil filter element
(Check element
for foreign particles)
.......................
.........
O O O
O
6. Check oil temperature
sender unit for
leaks and security ................
O O O
7. Check oil lines
and fitting for leaks, security,
chafing,
dents
and cracks (See Note 8) .......................................
O
O O O
8. Clean and check oil
radiator cooling fins ..............................
O O O
9. Remove
and flush oil radiator
(See Note 17) ..........................
O O
10. Fill engine with oil per information
in lubrication chart ...............
.. O O O O
11. Clean engine
...............
..............
...............
O O
O
CAUTION: Do
not contaminate
the vacuum
pump with cleaning
fluid.
(Ref: Latest Revision of
Lycoming Service Letter
No. 1221.)
12. Check
condition of
spark plugs (Clean
and adjust
gap as required.
adjust per latest
revision of Lycoming
Service Instruction No.
1042) ...............................
..............................
O
O O
NOTE: If fouling
of spark plugs has been apparent,
rotate bottom
plugs to
upper
plugs.
13. Inspect spark
plug cable leads and
ceramics for corrosion
and deposits
.......................................................
O O O
O
14. Check
cylinder compression (Ref: AC 43.13-1A)
....................... O
O
15. Check cylinders for
cracked or broken fins ............................
O O O
16. Check
rocker box covers for evidence
of oil leaks. If found,
replace gasket; torque cover screws 50 inch-pounds (See
Note 12) .........................................................
NOTE: Lycoming requires
a Valve Inspection be made
after every
400 hours of operation. (See Note 11)
17.
Check ignition harness and
insulators (high tension
leakage
and continuity) .................................................... O O O
18. Check
magneto points for proper
clearance (Maintain
clearance at 0.016) .................................................
O O O
19. Check
magneto for oil leakage .......................................
O O O
20. Check breaker felts
for proper lubrication .............................
O O O
21. Check distributor
block for cracks, burned
areas or
corrosion and height of contact
springs ...............................
O O
22. Check magnetos to
engine timing ....................................
O O O
23. Overhaul or replace magnetos
(See Note 7)...........................
24. Remove air filter
and clean per Section
VIII or VIIIA
(Replace
as required) ...............................................
O
O O O
INSPECTION
Revised: 10/3/80INSPECTION
1D13

Piper PA-32RT-300T Specifications

General

Brand	Piper
Model	PA-32RT-300T
Category	Aircrafts
Language	English