Piper PA-32RT-300T User Manual

1. Remove inspection
plates and
panels .................................
2.
Check baggage
doors, latch and
hinges for operation
and security
........
3.
Check battery,
box and cables
(Check at least
every 30 days.
Flush
box as required and fill battery
per instructions in Section
II)............
4. Check electronic installations
........................................
5. Check bulkheads
and stringers for damage
............................
6. Check antenna
mounts
and electric
wiring.............................
7. Inspect hydraulic
pump motor
brushes (See
Note 19) ...................
8. Check
hydraulic pump
fluid level (Fill
as required)
.....................
9. Check
hydraulic pump
lines for damage
and leaks
(Refer to latest
revision of Piper SB No. 616) ......................................
10. Check
for obstructions
and contamination
in inlet
of backup
landing
gear extender actuator inlet head .....................................
11. Check air conditioning
system for freon leaks..........................
12. Check
freon level in sight gauge
of receiver-dehydrator
(Refer to Section
XIV) ......................
......... .........
13. Check air conditioner
condenser air scoop for
proper operation
and
adjustment (Clean
as required)...................................
14.
Check fuel lines, valves, and gauges
for damage and operation...........
15. Remove,
drain, and clean fuel strainer
bowl and screen (Drain and
clean at least every
90 days) .........................................
16. Check security of all
lines ...........................................
17. Check
vertical fin
and rudder surfaces
for damage
......................
18. Check rudder
hinges, sector
and attachments
for damage,
security
and operation .....................................................
19. Inspect
rudder control stops to ensure
stops have not loosened and
locknuts are tight..................................................
20. Check vertical
fin attachments
for security .
21. Check rudder
hinge bolts
for excess wear
(Replace as required)
..........
22. Check
stabilator surfaces
for damage
.................................
23. Check stabilator
tab hinges. horn and
attachments for damage,
security and operation
..............................................
24. Inspect stabilator control
stops to ensure stops have
not loosened
and
locknuts are tight ..............................................
25. Check
stabilator attachments for security;
torque per Figure 4-3 .........
26. Check stabilator
and tab hinge bolts and
bearings for excess wear
(Replace
as required)
..............................................
27. Check
stabilator trim mechanism ....................................
28. Check
all cable tensions
(use tensiometer)
(See Note 18)
................
Revised:
11/1/83
1
1D17
LANCE
II SERVICE
MANUAL
TABLE III-I. INSPECTION REPORT
Inspection
Time
(hrs)
Nature of Inspection
50 100 500 1000
E.
FUSELAGE
AND
EMPENNAGE
GROUP
O
0
O 0
O 0
O 0 0
O 0 0
0
0
0
0
0
0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0
0
0
0 0 0
0 0 0
0 0 0
0 0 0
O 0 0
O O O
O O O
O O O
O
O
O
O O O
O O O
O 0 0
O 0 0
O 0 0
O 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0
0
0
INSPECTION

Piper PA-32RT-300T Specifications

General

Brand	Piper
Model	PA-32RT-300T
Category	Aircrafts
Language	English