Pitco SG Series - Taking a Manifold Gas Pressure Reading

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 17
TakingaManifoldGasPressureReading
1. Unscrew and remove the gas manifold plug with
a 3/16 inch hex wrench.
2. Finger tighten the test fitting into the test port.
3. Finish tightening the test fitting using a
7/16 inch open-ended wrench.
4. Connect the manometer.
5. If necessary, reconnect the solid state
thermostat (reverse steps for “Removing Solid
Stats Thermostat” on page 16.