Pitco SG Series - Adjusting Manifold Gas Pressure; Adjusting Pilot Pressure

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 18
AdjustingManifoldGasPressure
1. Check the manifold gas pressure with the
manometer and compare the reading to the
manifold gas pressure table.
ManifoldGasPressureTable
NAT LP
4.0” 10”
2. Insert a flathead screwdriver into the cap and
turn counter-clockwise to remove it.
3. Insert flathead screwdriver into the cap and turn
counter-clockwise to increase the gas pressure or
clockwise to decrease the gas pressure.
4. When adjustment is comp
lete:
a. Disconnect the manometer.
b. Remove the test fitting.
c. Reinstall the gas manifold plug.
d. Reconnect solid state thermostat.
e. Turn on gas supply line.
AdjustingPilotPressure
1. Remove pilot adjustment cap with Philips
screwdriver.
2. Rotate adjuster clockwise to decrease and
counter-clockwise to increase pilot flame.
3. Replace adjustment cap.