Pitco SG Series - Replacing the Return Switch

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 72
ReplacingtheReturnSwitch
1. Disconnect all the wires from the gas valve,
pilot, and SCB valve.
2. Drop the gas valve from the manifold.
3. Remove the two (2) screws, which hold the
return valve handle, using a 5/16 inch socket.
4. Remove the return valve handle bracket.
5. Remove the two (2) screws, which hold the
mounting bracket, using a 5/16 inch socket
6. Remove the mounting bracket.
7. Disconnect the mounting bracket wire from the
pump box (not shown).