Pitco SG Series - Replacing the Pump Relay

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers


ReplacingthePumpRelay
1. Remove the two (2) screws, which hold the
pump relay, using a Phillips screwdriver.
2. Remove all wires on the pump relay using
needle-nose pliers. See “Simplified Wiring
Diagrams on page 89.
3. Remove the pump relay.
4. Reinstall the new pump relay by following steps
1 through 2 in reverse.

SG/SSHSeriesServiceManual 76
