Pitco SG Series - Replacing the Controllers and Wiring Harness; Removing the Controller Front Panel Bezel

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 20
ReplacingtheControllersandWiringHarness
RemovingtheControllerFrontPanelBezel
1. Remove the two (2) screws on the controller
panel using a Phillips screwdriver.
2. Pull out the controller panel front bezel.
3. Disconnect the controller wiring harness.
4. Remove the four (4) screws on the back side of
the bezel using a 3/8 inch nut driver.