Pixsys ATR 142 - Memory Card (Optional)

18 - ATR142 - User manual
Setpoint
Time
Setpoint 1
Setpoint 2
Maintenance time
Mantenimento
Cooling
Rareddamento
Max Power
Max Potenza
Rising gradient
Gradiente di salita
Cycle starts at each activation
of the controller, or via
digital input if it is enabled
for this type of functioning
(parameter 50
d Gt.i .
).
8.8 Memory card (optional)
Parameters and setpoint values can be duplicated from one
controller to another using the Memory card.
There are two methods:
• With the controller connected to the power supply
Insert the memory card when the controller is off.
On activation display 1 shows
memo
and display 2 show
----
(Only if the correct values are saved in the memory
card). By pressing the “
n
” key display 2 shows
Lo a d
, then
confirm using the FNC key. The controller loads the new
data and starts again.
• With the controller not connected to power supply.
The memory card is equipped with an internal battery with
an autonomy of about 1000 operations.
Insert the memory card and press the programming
button.
When writing the parameters, the led turns to red and on
completing the procedure it turns to green. It is possible to
repeat the procedure without any particular attention.
Updating Memory Card
To update the memory card values, follow the procedure
described for the first method, setting display 2 to
----
so as
not to load the parameters on controller
1
.
Enter configuration level and change at least one parameter.
Exit configuration. Changes are saved automatically.
1
If on activation the controller does not display
memo
it means no data
have been saved on the memory card, but it is possible to update values.