Pixsys ATR 142 User Manual

34 - ATR142 - User manual
The input value (included between minimum and max limit)
is linearly converted into the retransmitted value which is
included between min and max output value. Rescaling is not
executed if parameters
Lo . L. r.
and
u p . L. r.
have the same value.
10.2.2 Master Mode Remote process
To enable this function it is necessary to select
r. p r o .
on
parameter 59
mast
. In this mode the process value on ATR142
is a value read via serial communication. The ID of the slave
must be same as value selected on parameter 57
sL. a d .
and
the word to read is selected on parameter 60
add.r
. Two
successive pollings will be delayed for the time selected
on parameter 57
se. d e.
The read value might be rescaled
according to the proportion described in the following table:
mast.
Limits of read value Limits of rescaled value
Min Max Min Max
r. p r o . 
Read
Process
Lo . L. r. 
Lower
Limit
Re-
transmis-
sion
u p . L. r. 
Upper
Limit
Re-
transmis-
sion
Lo .L.i . 
Lower
Limit Input
u p. L.i .
Upper
Limit Input
11 Configuration
11.1 Modify Configuration Parameter
For configuration parameters (parameter 11.)
Press Effect Do
1
FNC for 3s
Display 1 shows
0000
with the 1st
digit flashing, while
display 2 shows pass.
2
“n” and “m”
Change the flashing
digit and move to
the next one using
the SET key.
Enter password
1234

Pixsys ATR 142 Specifications

General

Brand	Pixsys
Model	ATR 142
Category	Controller
Language	English