46
State of OUT2 led
Alarm 1 hysteresis
Alarm1 delay
Alarm 1 set protection
Alarm 2 selection
Alarm 2 output contact and intervention type
Reset type of alarm 2 contact
State of contact for alarm 2 output
State of OUT2 led
Alarm 2 hysteresis
Alarm 2 delay
Alarm 2 set protection
Cooling fluid type
Proportional band multiplier
Overlapping/Dead band
Cycle time for cooling output
Analog converter filter
Sampling frequency of analog converter
Display filter
Autotuning type selection
Command setpoint deviation for tuning threshold
Operating mode
Automatic/manual selection
Digital input functioning
Gradient for soft start
Cycle maintenance time
Gradient change and maintenance time by user
Display data selection
Degree type selection
Select baud rate for serial communication
Select slave address
Select the serial delay
Select value to retransmit by ModBus
To Next Page
Loading...
