Pixsys ATR142 - 14 Summary of Configuration Parameters

45
14 Summary of Configuration parameters
Date: Model ATR142:
Installer: System:
Notes:
Command output type selection
Analog input configuration
Number of decimal points
Lower limit setpoint
Upper limit setpoint
Lower limit range An1 only for linear
Upper limit range An1 only for linear
Automatic setting of linear input limits.
Offset calibration
Gain calibration
Regulation type
Command output reset type
Contact state for command output in case of error
Define the OUT1 led state
Hysteresis in ON/OFF or dead band in P.I.D.
Command delay
Command setpoint protection
Proportional band
Integral time
Derivative time
Cycle time
Limit of output power %
Alarm 1 selection
Alarm 1 output contact and intervention type
Reset type of alarm 1 contact.
State of contact for alarm 1 output