Pixsys ATR142 - Loading Default Values; 8 LATCH on Functions

15
7.9 Loading default values
This procedure makes it possible to restore factory settings of the
instrument.
Premere Effetto Eseguire
1
F
N
C
for 3
seconds.
Display 1 shows
with the 1st digit
flashing, while display 2
shows
2
or
Change the flashing digit
and move to the next
one using the
S
E
T
key.
Enter password
3
S
E
T
to confirm
Instrument loads default
settings
Turn off and on the
instrument
8 LATCH ON Functions
For use with input (potentiometer 6KΩ) and
(potentiometer 150KΩ ) and with linear input (0…10V, 0...40mV,
0/4…20mA), you can associate start value of the scale (parameter 6
) to the minimum position of the sensor and value of the scale
end (parameter 7 ) to the maximum position of the sensor
(parameter 8 configured as ).
It is also possible to fix the point in which the controller will display 0
(however keeping the scale range between and )
using the “virtual zero” option by setting
or in
parameter 8 . If you set the virtual zero will reset after
each activation of the tool; if you set the virtual zero remains
fixed once tuned.