User manual - ATR144- 51
23
c . r e .1
Command Reset 1
Type of reset for command contact 1 (always automatic
in P.I.D. functioning)
A. rEs.
Automatic Reset (Default)
M. rEs.
Manual Reset (by keyboard
or by digital input).
M.rEs.S.
Manual Reset Stored (keeps relay status
also after an eventual power failure).
A. r E s.t.
Automatic reset with timed activation.
The command remains active for the time
set on the parameter c. d e.1., even if the
conditions generating it are missing. To
be able to act again, the conditions for
activating the command must disappear.
24
c . S . e .1
Command State Error 1
State of contact for command 1 output in case of error.
If the command output 1 (Par. 18 c . o u .1 ) is relay or
valve:
open
Contact or valve open. Default
CLose
Contact or valve closed.
If the command output is digital output (SSR):
off
Digital output OFF. Default
on
Digital output ON.
25
c . L d .1
Command Led 1
Defines led C1 state corresponding to the related
output. If the valve command is selected, this parameter
is not managed.
o.c.
ON with open contact or SSR switched off.
c.c.
ON with closed contact or SSR
switched on. (Default)
To Next Page
Loading...
