Pixsys ATR144 - Page 52

52 - ATR144 - User manual
26 c.de.1 Command Delay 1
Command 1 delay (only in ON / OFF functioning).
-60:00..60:00 mm:ss. Default: 00:00.
Negative: delay when turning off output.
Positive: delay when turning on output.
27 c . S . p .1 Command Setpoint Protection 1
Controls access to the command setpoint 1 value
FrEE Modification allowed (Default)
Lock Protected
Hid E Protected and not displayed
28 v A . t .1 Valve Time 1
Valve time related to command 1 (declared by the
manufacturer of the valve)
1...300 seconds. Default: 60.
29 a.ma.1 Automatic / Manual 1
Enables the automatic/manual selection for command
1
diS a b. Disabled (Default)
En a b. Enabled
En.St o. Enabled with memory
30 i ni .S. Initial State
Choose the state of the controller when turning it
on. This only works on the version ATR144-ABC-T or
by enabling the Start/Stop from digital input or SET
button.
start Start (Default)
stop Stop
s t o r e. Stored. State of Start/Stop
prior to switching off.
31÷35 Reserved Parameters - Group B
Reserved parameters - Gruppo B