Pixsys ATR144 - Page 76

76 - ATR144 - User manual
164 V A r.1 Variable 1
Selects the variable 1 used by the ATR144 in master
mode.
---- Reserved
W. Pro. Write Process (Default)
r. W .c.S E. Read/write command setpoint
w.c.o u.p. Write command output percentage
r. W . A1.s. Read/Write Alarm 1 setpoint
W.co ns. Write constant
r. P ro. Read Process (remote process
from modbus master)
165 V .1 . a d . Variable 1 Address
Sets the address used by the master to write/read V A R.1
0..65535. Default: 1000.
166 L.L. v .1 Lower Limit Variable 1
Lower range limit used for rescaling variable 1
-9999..+30000 [digit
1 p. 86
] (degrees for temperature
sensors). Default: 0.
167 u.L.v.1 Upper Limit Variable 1
Upper range limit used for rescaling variable 1
-9999..+30000 [digit
1 p. 86
] (degrees for temperature
sensors). Default:0
168 c o n .1 Constant 1
Sets the constant value that will be transmitted while
operating in master mode, if selected on V A R.1
0..65535. Default: 0.