Advanced Settings Menu
46 ep46L/ep55L User Manual
This feature is used to amplify all colors except that of people’s faces.
Options: Off, Low, Medium and High (Video Mode only)
Default: Off
IRFM
Creates slight frame motion to help avoid image retention.
Options: On
Default: Off
Baud Rate
Options: 115200, 38400, 19200, 9600
Default: 19200
Smart light control
Options: Off, DCR, Light Sensor
Default: Off
Ethernet Setup
Configure Network settings. See "Web Service" on page 52 for more information.
Lamp Saver
Lamp Saver On - The backlight will go into sleep mode after no signal is detected
after the specified amount of time in the
OSD TIMEOUT line on the BASIC
SETTINGS menu.
Lamp Saver Off - The “no signal” message will disappear after 30 seconds and the
backlight will always remain on.
Options: Off, On
Default: Off
Factory Reset
Restores all settings to their defaults.
Options: No, Yes
Default: No
To Next Page
Loading...
