8-4
both: Configure the LLDP function as being able to both send and receive messages.
disable: Configure the LLDP function as not being able to send or receive messages.
Default:
The operating state of the port is “both”.
Command Mode:
Port Configuration Mode.
Usage Guide:
Choose the operating state of the lldp Agent on the port.
Example:
Configure the state of port ethernet 1/0/5 of the switch as “receive”.
Switch(config)#in ethernet 1/0/5
Switch(Config-if-Ethernet 1/0/5)#lldp mode receive
8.7 lldp msgTxHold
Command:
lldp msgTxHold <value>
no lldp msgTxHold
Function:
Set the multiplier value of the aging time carried by update messages sent by the all ports with
LLDP function enabled, the value ranges from 2 to 10.
Parameters:
<value> is the aging time multiplier, ranging from 2 to 10.
Default:
the value of the multiplier is 4 by default.
Command Mode:
Global Mode.
Usage Guide:
After configuring the multiplier, the aging time is defined as the product of the multiplier and the
interval of sending messages, and its maximum value is 65535 seconds.
Example:
Set the value of the aging time multiplier as 6.
Switch(config)#lldp msgTxHold 6
To Next Page
Loading...
