Planet SGS-6341 Series - Show Ip Bgp

37-317
Switch(config-router)#neighbor 10.1.1.68 route-map map1 in
Switch(config-router)#address-family vpnv4 unicast
Switch(config-router-af)#neighbor 10.1.1.68 activate
Switch(config-router-af)#exit-address-family
View the route message after refresh:
Switch#show ip bgp vpnv4 all
Network Next Hop Metric LocPrf Weight Path
Route Distinguisher: 100:10 (Default for VRF DC1)
*> 11.1.1.0/24 11.1.1.64 0 0 200 ?
*>i15.1.1.0/24 10.1.1.250 0 100 655 200 ?
*> 20.1.1.0/24 11.1.1.64 0 0 200 ?
*>i100.1.1.0/24 10.1.1.250 0 100 655 200 ?
Route Distinguisher: 100:10
*>i15.1.1.0/24 10.1.1.68 0 100 0 200 ?
*>i100.1.1.0/24 10.1.1.68 0 100 0 200 ?
We can see that the nexthop 10.1.1.68 of the VPN route is changed to 10.1.1.250 after applied with
route-map.
37.88 show ip bgp
Command:
show ip bgp [<ADDRESS-FAMILY>] [<ip-address>|<ip-address/M> [longer-prefixes]|
cidr-only]
Function:
For displaying the routing messages permitted by BGP.
Parameter:
<ADDRESS-FAMILY>: address-family such as “ipv4 unicast”
<ip-address>: IP address
<ip-address/M>: IP address and the mask
Command Mode:
Admin and configuration mode
Usage Guide:
We can display BGP routing messages by different parameters (such as address-family or IPv4
address), or a route covered by a prefix, or only the routing message don’t match the earliest IP
address-family (namely the route is not A or B or C type address.)