Planet SGS-6341 Series - Service-Policy Input Vlan

15-140
Usage Guide:
Only one policy map can be applied to each direction of each port. Egress policy map is not
supported yet.
Example:
Bind policy p1 to ingress Ethernet port1/0/1.
Switch(config)#interface ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)#service-policy input p1
Bind policy p1 to ingress redirection of v1 interface.
Switch(config)#interface vlan 1
Switch(Config-If-vlan1)#service-policy input p1
15.20 service-policy input vlan
Command:
service-policy input <policy-map-name> vlan <vlan-list>
no service-policy input <policy-map-name> vlan < vlan-list>
Function:
Applies a policy map to the specified VLAN interface; the no command deletes the specified policy
map applied to the VLAN interface.
Parameters:
input <policy-map-name> applies the specified policy map to the ingress direction of switch VLAN
interface.
Default:
No policy map is bound to port and VLAN interface by default.
Command mode:
Global Configuration Mode.
Usage Guide:
Only one policy map can be applied to each direction of each VLAN interface. Use the policy-map
on the port at first when binding policy-map on VLAN and VLAN's port at the same time. Egress
policy map is not supported yet.
Example:
Bind policy p1 to ingress of VLAN interface v2, v3, v4, v6.
Switch(config)# service-policy input p1 vlan 2-4;6