9-16
Command mode:
Port Mode
Default:
Long.
Usage Guide:
Set the timeout mode of LACP protocol.
Example:
Set the timeout mode as short in LACP protocol.
Switch(Config-If-Ethernet1/0/1)#lacp timeout short
9.6 load-balance
Command:
load-balance {dst-src-mac | dst-src-ip | dst-src-mac-ip}
Function:
Set load-balance mode for switch, it takes effect for port-group and ECMP at the same time.
Parameter:
dst-src-mac performs load-balance according to the source and destination MAC
dst-src-ip performs load-balance according to the destination and source IP
dst-src-mac-ip performs load-balance according to the destination and source MAC, the destination
and source IP
Command mode:
Global mode.
Default:
Perform load-balance according to the source and destination MAC.
Usage Guide:
Use port-channel or ECMP to implement load-balance, user can configure the load-balance mode
according to the requirements. If the specific load-balance mode of the command line is different
with the current load-balance mode, then modify the load-balance as the specific load-balance of
command line; otherwise return a message to notice that the current mode is already configured.
Example:
Set load-balance mode.
Switch(config)# load-balance src-mac-ip
To Next Page
Loading...
