Planet SGS-6341 Series - Snmp-Server Enable Traps

SGS-6341 Series Command Guide
1-90
Command mode:
Global mode
Default:
SNMP proxy server function is disabled by system default.
Usage guide:
To perform configuration management on the switch with network manage software, the SNMP proxy server function
has to be enabled with this command.
Example:
Enable the SNMP proxy server function on the switch.
Switch(config)#snmp-server enable
1.4.14 snmp-server enable traps
Command:
snmp-server enable traps
no snmp-server enable traps
Function:
Enable the switch to send Trap message; the “no snmp-server enable traps” command disables the switch to send
Trap message.
Command mode:
Global Mode
Default:
Forbid to send Trap message.
Usage Guide:
When Trap message is enabled, if Down/Up in device ports or of system occurs, the device will send Trap messages
to NMS that receives Trap messages.
Example:
Enable to send Trap messages.
Switch(config)#snmp-server enable traps
Disable to send Trap messages.
Switch(config)#no snmp-server enable traps