Planet SGS-6341 Series - Page 358

19-204
Enables the ARP debugging function; the “no debug arp {receive|send|state}” command disables
this debugging function.
Parameter:
receive the debugging-switch of receiving ARP packets of the switch; send the debugging-switch of
sending ARP packets of the switch; state the debugging-switch of APR state changing of the switch.
Default:
ARP debug is disabled by default.
Command mode:
Admin Mode.
Usage Guide:
Display contents for ARP packets received/sent, including type, source and destination address,
etc.
Example:
Enabling ARP debugging.
Switch#debug arp receive
%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251, 00-e0-4c-88-ad-bc,
dst 172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf Vlan100.
%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251, 00-e0-4c-88-ad-bc,
dst 172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf Vlan100.
e%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251, 00-e0-4c-88-ad-bc,
dst 172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf Vlan100.
%Jan 01 01:05:53 2006 IP ARP: rcvd, type REQUEST, src 172.16.1.251, 00-e0-4c-88-ad-bc,
dst172.16.1.110, 00-00-00-00-00-00 flag 0x0, pkt type 1, intf Vlan100.
19.5.5 ip proxy-arp
Command:
ip proxy-arp
no ip proxy-arp
Function:
Enables proxy ARP for VLAN interface; the “no ip proxy-arp” command disables proxy ARP.
Default:
Proxy ARP is disabled by default.
Command mode:
VLAN Interface Mode
Usage Guide:
When an ARP request is received on the layer 3 interface, requesting an IP address in the same IP