Planet SGS-6341 Series - Page 380

25-19
Function:
Show IPv4 running status of the specified interface.
Parameters:
interface-name is the specified interface name. If there is no parameter, show IPv4 running status of
all interfaces.
Command Mode:
Policy-class-map Mode.
Usage Guide:
Show IPv4 running status of the interface.
Example:
Switch(config)#show ip interface brief
Index Interface IP-Address Protocol
3001 Vlan1 1.1.1.2 up
9000 Loopback 127.0.0.1 up
25.3 show keepalive gateway
Command:
show keepalive gateway [interface-name]
Function:
Show keepalive running status of the specified interface.
Parameters:
interface-name is the specified interface name. If there is no parameter, show keepalive running
status of all interfaces.
Command Mode:
Admin and configuration mode.
Usage Guide:
Show keepalive running status of the interface.
Example:
Switch(config)#show keepalive gateway
interface Vlan1 gateway 1.1.1.1 time 10s retry 1 remain 4 now UP