Planet SGS-6341 Series - Page 386

26-25
Function:
Configure DNS servers for DHCP clients; the “no dns-server” command deletes the default
gateway.
Parameters:
<address1>…<address8> are IP addresses, in decimal format.
Default:
No DNS server is configured for DHCP clients by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
Up to 8 DNS server addresses can be configured. The DNS server address assigned first has the
highest priority, therefore address 1 has the highest priority, and address 2 has the second, and so
on.
Example:
Set 10.1.128.3 as the DNS server address for DHCP clients.
Switch(dhcp-1-config)#dns-server 10.1.128.3
26.1.11 domain-name
Command:
domain-name <domain>
no domain-name
Function:
Configures the Domain name for DHCP clients; the “no domain-name” command deletes the
domain name.
Parameters:
<domain> is the domain name, up to 255 characters are allowed.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
Specifies a domain name for the client.
Example:
Specifying “digitalchina.com.cn" as the DHCP clients’ domain name.
Switch(dhcp-1-config)#domain-name digitalchina.com.cn