Planet SGS-6341 Series - Page 406

27-45
Command Mode:
DHCPv6 Address Pool Configuration Mode.
Usage Guide:
For each address pool, at most three DNS server can be configured, and the addresses of the DNS
server must be valid IPv6 addresses.
Example:
To configure the DNS Server address of DHCPv6 client as 2001:da8::1.
Switch(dhcp-1-config)#dns-server 2001:da8::1
27.9 domain-name
Command:
domain-name <domain-name>
no domain-name <domain-name>
Function:
To configure domain name of DHCPv6 client; the no form of this command will delete the domain
name.
Parameter:
<domain-name> is the domain name, less than 32 characters.
Command Mode:
DHCPv6 Address Pool Configuration Mode.
Default:
The domain name parameter of address pool is not configured by default.
Usage Guide:
At most 3 domain names can be configured for each address pool.
Example:
To set the domain name of DHCPv6 client as test.com.cn
Switch(dhcp-1-config)#domain-name test.com.cn
27.10 excluded-address
Command:
excluded-address <ipv6-address>
no excluded-address <ipv6-address>
Function: