34-184
Aggregated
To configure the interface name of the aggregation route. If the route
aggregated globally, then display “---”.
Metric of aggregation route.
The number of learned aggregation routes.
The times of aggregated for aggregation route.
34.26 show ipv6 rip redistribute
Command:
show ipv6 rip redistribute
Function:
Show the configuration information of redistributed other out routing to RIPng.
Default:
Not shown by default.
Command Mode:
Admin Mode and Configuration Mode.
Example:
Switch#show ipv6 rip redistribute
34.27 timers basic
Command:
timers basic <update> <invalid> <garbage>
no timers basic
Function:
Adjust the RIP timer update, timeout, and garbage collecting time. The “no timers basic” command
restores each parameters to their default values.
Parameter:
<update> time interval of sending update packet, shown in seconds and ranging between
5-2147483647;
<invalid> time period after which the RIP route is advertised dead, shown in seconds and ranging
between 5-2147483647;
<garbage> is the hold time in which the a route remains in the routing table after advertised dead,
shown in seconds and ranging between 5-2147483647.
Default:
To Next Page
Loading...
