Planet SGS-6341 Series - Page 662

37-301
Switch(config-router)#neighbor 10.1.1.64 port 1023
37.65 neighbor prefix-list
Command:
neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number> {<in|out>}
no neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number> {<in>|<out>}
Function:
Configure the prefix restrictions applied in sending or receiving routes from specified neighbors.The
“no neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number> {<in>|<out>}” command
cancels this configuration.
Parameter:
<ip-address>: Neighbor IP address.
<TAG>: Name of the peer group.
<LISTNAME|number>: Name or sequence number of the prefix-list.
<in|out>: Direction on which the restrictions applied.
Default:
No prefix restrictions applied.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
Specify the prefix and its scope by configuring ip prefix-list and determines whether this scope is
permitted or denied. Only the route with permitted prefix will be sent or received.
Example:
Switch(config)#ip prefix-list prw permit 100.1.0.0/22 ge 23 le 25
Switch(config)#router bgp 200
Switch(config-router)#redistribute static
Switch(config-router)neighbor 10.1.1.66 prefix-list prw out
37.66 neighbor remote-as
Command:
neighbor {<ip-address>|<TAG>} remote-as <as-id>
no neighbor {<ip-address>|<TAG>} [remote-as <as-id>]
Function: