Planet SGS-6341 Series - Page 837

44-113
Global mode
Default:
255s
Usage Guide:
This command validates on dynamic mrouter ports but not on mrouter port. To use this command,
IGMP Snooping of this VLAN should be enabled previously.
Example:
Switch(config)#ip igmp snooping vlan 2 mrpt 100
44.10.15 ip igmp snooping vlan query-interval
Command:
ip igmp snooping vlan <vlan-id> query-interval <value>
no ip igmp snooping vlan <vlan-id> query-interval
Function:
Configure this query interval.
Parameter:
vlan-id: VLAN ID, ranging between <1-4094>
value: query interval, ranging between <1-65535>seconds
Command Mode:
Global mode
Default:
125s
Usage Guide:
It is recommended to use the default settings. Please keep this configure in accordance with IGMP
configuration as possible if layer 3 IGMP is running.
Example:
Switch(config)#ip igmp snooping vlan 2 query-interval 130
44.10.16 ip igmp snooping vlan query-mrsp
Command:
ip igmp snooping vlan <vlan-id> query-mrsp <value>
no ip igmp snooping vlan <vlan-id> query-mrsp
Function:
Configure the maximum query response period. The “no ip igmp snooping vlan <vlan-id>