¾
Operation Mode - Displays the current operation mode of the AP.
¾
WPS Status - To enable or disable the WPS function here.
¾
Current PIN - The current value of the AP's PIN is displayed here.
¾
Restore PIN - Restore the PIN of the AP to its default.
¾
Gen New PIN - Click this button, and then you can get a new random value for the AP's PIN.
You can ensure the network security by generating a new PIN.
¾
Add device - You can add a new device to the existing network manually by clicking this
button.
To add a new device:
If the wireless adapter supports Wi-Fi Protected Setup (WPS), you can establish a wireless
connection between wireless adapter and access point using either Push Button Configuration
(PBC) method or PIN method.
)
Note:
To build a successful connection by WPS, you should also do the corresponding configuration of
the new device for WPS function meanwhile.
For the configuration of the new device, here takes the WNL-U554A Wireless USB Adapter of our
company for example.
I. By PBC
If the wireless adapter supports Wi-Fi Protected Setup and the Push Button Configuration (PBC)
method, you can add it to the network by PBC with the following two methods.
Method One:
Step 1: Open the WNL-U554A Configuration Utility and click “WPS” tab.
Step 2: Set "Config Mode" to "Enrollee", and then push the "WPS" button on the front of AP.
15
To Next Page
Loading...
