Planmeca Chair - 13 Technical Specifications

13 TECHNICAL SPECIFICATIONS
28 Planmeca Chair User’s manual
13 TECHNICAL SPECIFICATIONS
Construction Cast alloy (all metal)
Weight 120 kg (290 lbs.)
Backrest angle 25° upright from vertical
90° lowest from vertical
Swivel ±90°, total 180°
Operation Electromechanical (2 motors)
Control Microprocessor
Ambient temperature Operating +15 °C to +35 °C (59 °F to 95 °F)
Storage -5 °C to +60 °C (23 °F to 140 °F)
Ambient air pressure 800 hPa to 1060 hPa (12 psi to 15 psi)
Relative humidity 5% RH to 95% RH; non-condensing humidity
Altitude < 2000 m (less than 1.25 miles)
Power requirements 3A/220-240 VAC 50Hz/60Hz
6A/100, 115 VAC 50Hz/60Hz
ED 8% 25 sec. “ON”, 300 sec. “OFF”
Electrical classification Class I, type B
Foot control Class IPx1
Maximum lifting capacity, excluding the weight of additional equipment
IEC 60601-1 Second edition 1988-12 135 kg
IEC 60601-1 Third edition 2005-12 160 kg
Maximum allowed weight of additional equipment to be attached to the chair
55 kg
Maximum allowed torque caused by additional equipment on chair adapter interface or on
Planmeca SingLED / OP tray adapter 365 Nm
Maximum allowed weight of additional equipment on Planmeca SingLED / OP tray adapter
50 kg
Original manufacturer
PLANMECA Oy, Asentajankatu 6, FIN-00880, Helsinki, FINLAND
Phone: +358-20-7795 500, fax: +358-20-7795 555
220-240 V~ 115 V~ 100 V~
Plug Fuse 2 x F 4 A H 250V
Bussmann S501-4-R
Schurter 0001.1010
2 x F 8 A H 250V
Bussmann S501-8-R
Schurter 0001-1013
2 x F 8 A H 250V
Bussmann S501-8-R
Schurter 0001-1013
Label LBL-10026426 LBL-10027254 LBL-10027253
Fixed Fuse 1 x F 4 A H 250V 1 x F 8 A H 250V 1 x F 8 A H 250V
Label LBL-10027258 LBL-10027256 LBL-10027255