ENGINE
3.43
NOTE: Be sure to place the tapered end of the valve
(dowel) in first. If the valve is installed incorrectly, oil
pressure and oil priming problems will occur.
DISASSEMBLY OF WATER/OIL PUMP SHAFT
WARNING
Wear appropriate safety gear
during this procedure. Protective gloves,
clothing and eyewear are required.
32. Carefully press the gear off the assembly while
supporting the housing assembly.
Press off gear
33. Remove the snap ring from the assembly. Place
the housing in a support and press out the
bearing/shaft assembly.
Retaining Ring
Bearing
Press out
shaft and
bearing
assembly
34. Place the shaft in a press to remove the bearing.
Bearing
To Next Page
Loading...
