ELECTRICAL
10.36
FUEL SENDER TEST
1. Remove the fuel sender from the fuel tank. Refer
to Chapter 4 “FUEL SENDER
REMOVAL/INSTALLATION”.
2. Stand the fuel sender on a flat surface.
3. Hook up an ohm meter to the fuel sender harness
(Brown & Purple / White).
4. With the sender float in the empty position,the
meter should read 5 ohms.
5. Slowly lift the sender float to the full position,the
meter should now read 90 ohms.
6. If the reading are not between 5 ohms and 90
ohms
, or if the reading is erratic, replace the fuel
sender.
To Next Page
Loading...
