BODY / STEERING / SUSPENSION
5.4
FRONT COVER REMOVAL /
INSTALLA
TION
1. Remove the front cover shield screws (A) (2
philiips screws), if needed.
A
2. Pull up and outward on the front cover to remove
the cover.
3. To install the front cover, insert the tabs of thefront
cover into the inserts of the cab. Make sure the
tabs are aligned with the slots. Then press the
rear tabs into the slots. Reinstall cover shield.
PLASTIC FOOT WELL
REMOVAL / INSTALLA
TION
1. Remove the four plastic inserts (A) that secure
the wheel well to the front and rear cabs. (See
“PLASTIC INSERT REMOVAL /
INSTALLATION” for help).
2. Remove the two bolts (D) and three T--27 torx
screws (E) that secure the outside footwell plates
to the frame.
D
14--16 ft.lbs.
(19--22 Nm)
D
E
14--16 ft.lbs.
(19--22 Nm)
3. Remove the four screws (B) from the bottom of
the foot well. Remove the phillips screw (C)
located at the front of the footwell and in front
mudflap. Remove the footwell.
A
A
B
18 in.lbs.
(2 Nm)
C
To Next Page
Loading...
