ELECTRICAL
10.35
TAIL LIGHT/BRAKE LIGHT
LAMP
REPLACEMENT
If the tail light/brake light does not work the lamp may
need to be replaced.
Rear Tail Light
Lens Cover
Bulb
1. From the rear of the tail light remove two screws
holding lens cover in place and remove lens
cover.
2. Remove lamp and replace it with recommended
lamp. Apply Dielectric Grease (PN 2871329).
3. Reinstall the lens cover removed in Step 1.
4. Test the tail light/brake light to see it is working.
BRAKE LIGHT SWITCH
1. Remove the front cover.
Brake Lamp Switch
Brake Switch Location: Under
front cover below headlight pod.
2. Disconnect wire harness from switch.
3. Connect an ohmmeter across switch contacts.
Reading should be infinite (∞).
4. Apply brake at handlebar lever and check for
continuity between switch contacts. Replace
switch if there is no continuity or greater than .5
ohms resistance when the brake is applied with
slight pressure.
To Next Page
Loading...
