ENGINE
3.54
35. Install the gear/stator housing gasket onto he
crankcase.
Gear/Stator
Housing Gasket
36. Secure the gear/stator housing cover (O) to the
crankcase with the cover bolts. Torque bolts to 96
± 12 in.lbs. (10.85 ± 0.35 Nm) in proper tightening
sequence (see Pg. 3.3). Remove seal protectors
from the shaft ends once secure.
(PA--45401)
(PA--45658)
O
Gear/Stator Housing Bolt Torque:
96 ± 12 in. lbs. (10.85 ± 0.35 Nm)
*Torque in Proper Sequence (Pg. 3.3)
NOTE: Before assembly, clean the bolts and bolt
holes with Primer N (PN 2870585) to remove any
debris. This will ensure proper sealing when installing
bolts.
37. Install shaft seal with ceramic surface facing
inward.
38. Install water pump impeller (P). Secure the
impeller with the washer and a new nylok
nut
(Q)
. Torque the nut to 108 ± 12 in. lbs. (6.8 ± 0.68
Nm).
P
Q
Water Pump Impeller Nut Torque:
108 ± 12in.lbs.(6.8± 0.68 Nm)
To Next Page
Loading...
