CLUTCH
6.20
inward. Remove snap ring (A).
Press Down
on Spider
5. Remove the spider assembly, spring (B), and
spacer washer (C). NOTE: The spring is a
compression spring only and has no torsional
wind.
B
C
SPIDER DISASSEMBLY
6. Remove the inside spider plate (D) and spider
dampener (E). Inspect the spider dampener (E)
for wear and replaced if needed.
E
D
7. Remove the E--clip (F), washer (G), and the
clutch rollers (H). Inspect the rollers for wear
replace if worn.
F
G
H
8. Remove the clutch assembly from the holding
tool. Remove the large outer retaining ring (I) and
the inner retaining ring (J).
I
J
To Next Page
Loading...
